You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 8
Next »
If the USB microcontroller (Cypress EZ-ESB FX2) TE USB FX2 driver is not installed on the host computer, then the easiest way to do it, is the following:
- disconnect the TE USB FX2 module if it connected or leave the module unconnected;
- turn off the TE USB FX2 module;
- set “EEPROM” switch to EEPROM connection enabled (EEPROM disconnected from USB microcontroller) (1);
- turn on the TE USB FX2 module;
- if the TE0300 module is used, the S2 switch must be turned on (RUN);
- if the TE0320 module is used, the S1D switch must be turned on (RUN);
- connect (aka plug in, aka attach) the TE USB FX2 module to the host computer through the USB interface;
- wait until the operating system detects new hardware and starts the hardware assistant;
module enumerates in normal mode
Generation 2: VID = 0x0547, PID = 0x1002;
- Generation 3 : VID = 0x0BD0 , PID = 0x0300;