You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 4 Next »

Overview

The Trenz Electronic TE0729 is an industrial-grade SoM (System on Module) based on Xilinx Zynq-7000 SoC (XC7Z020).

This SoM has following peripherals on board:

  • 1 x Gbps Ethernet Phy transceiver
  • 2 x 100 Mbps Ethernet PHY transceivers
  • 512 MByte DDR3 SDRAM
  • 32 MByte Flash-Memory
  • 4 Gbyte NAND-Flash-Memory
  •  USB PHY transceiver
  • powerful switch-mode power supplies for all on-board voltages
  • large number of configurable I/Os is provided via rugged high-speed stacking strips

All modules in 4 x 5 cm form factor are mechanically compatible.

Block diagram

Board Components

Main Components:

Key Features

  • Industrial-grade Xilinx Zynq-7000 (XC7Z020) SoM
  • Rugged for shock and high vibration
  • 2 x ARM Cortex-A9
  • 1 x 10/100/1000 Gbps Ethernet transceiver PHY
  • 2 x 10/100 Mbps Ethernet transceiver PHYs
  • 3 x MAC-Address EEPROMs
  • 16-Bit wide 512 MByte DDR3 SDRAM
  • 32 MByte QSPI-Flash-Memory
  • 4 GByte NAND-Flash-Memory (embedded eMMC Memory)
  • Programmable Clock Generator
    • Transceiver Clock (default 125 MHz)
  • USB 2.0 high-speed ULPI transceiver
  • 4 GTP/GTX (high-performance transceiver) lanes
    • GTP/GTX (high-performance) clock input
  • Plug-on module with 2 x 120-pin high-speed hermaphroditic strips
  • 136 FPGA I/Os (58 LVDS pairs possible) and 6 PS MIO available on board-to-board connectors
  • On-board high-efficiency DC-DC converters
    • 4.0 A x 1.0 V power rail
    • 1.5 A x 1.5 V power rail
    • 1.5 A x 1.8 V power rail
    • 1.5 A x 2.5 V power rail
  • System management
  • eFUSE bit-stream encryption
  • AES bit-stream encryption
  • Temperature compensated RTC (real-time clock)
  • User LED
  • Evenly-spread supply pins for good signal integrity

Assembly options for cost or performance optimization available upon request.

 

Signals, Interfaces and Pins

System Controller I/O Pins

Special purpose pins used by TE0729

NameNote
NRST 
NRST_IN 

 

Boot Modes

By default the TE-0729 supports QSPI-Flash-Memory, JTAG and SD-Card (if available on base board) boot modes.

The boot modes are controlled by the Pins 'BOOT1' and 'BOOT2'.

Pin-Configuration

BOOTMODE1 / BOOTMODE2

boot mode
LOW / LOW 
LOW / HIGH 
HIGH / LOW 
HIGH / HIGH 

 

 

 

  • No labels