JTAG signals are available at:
The offset holes of header J2 allow a removable press fit of standard 0.100 inch header pins to connect flying leads without any soldering necessary.
JTAG signals are available on the dedicated header J2 through a JTAG programmer with flying leads as described in the table below.
|
To connect your computer to JTAG connector J2, you typically need
Some examples of JTAG cable set are listed in the table below.
|
Figure below shows a standard 6-pin JTAG female header, in this case flying leads, with a gender changer header.
The JTAG is ideal for quick configuration and effective debugging.
JTAG signal lines are also available at B2B connector JM4 (pins 70, 72, 74, 76, 78 and 80). See the corresponding pin-out table for additional information on these signals.