To see the device status you should open "Device Manager" using one of this two procedure:
|
If the TE0300 module is used, the S2 switch must be turned on (RUN). If the TE0320 module is used, the S1D switch must be turned on (RUN). |
TE USB FX2 module starts as a DEWESoft device (at power on) (Generation 2) when
If DEWESoft driver is not installed, this immage appears in Windows "Device manager"
![]() |
If DEWESoft driver is installed, one of these two immage appears in Windows "Device manager"
|
TE USB FX2 module starts as a TE device (at power on) (Generation 3) when
If TE USB FX2 driver is not installed, this immage appears in Windows "Device manager"
![]() |
If TE USB FX2 driver is installed, this immage appears in Windows "Device manager"
![]() |
TE USB FX2 module starts as a Cypress device (at power on) when
If Cypress USB Generic Driver is not installed this immage appears in Windows "Device manager"
![]() |
If Cypress USB Generic Driver is installed, this immage appears in Windows "Device manager"
![]() |