If the USB microcontroller (Cypress EZ-ESB FX2) TE USB FX2 driver is not installed on the host computer, then the easiest way to do it, is the following:
- disconnect the TE USB FX2 module if it connected or leave the module unconnected;
- turn off the TE USB FX2 module;
- set “EEPROM” switch to EEPROM connection enabled (EEPROM disconnected from USB microcontroller) (1);
- turn on the TE USB FX2 module;
- if the TE0300 module is used, the S2 switch must be turned on (RUN);
- if the TE0320 module is used, the S1D switch must be turned on (RUN);
- connect (aka plug in, aka attach) the TE USB FX2 module to the host computer through the USB interface;
- starts the hardware assistant;
- answer the hardware assistant questions as shown in the following document and in this video play lists;
The driver package contains many folders. During installation, the user shall specify the folder according to 32 (x86)/ 64 (x64) bit distinction and the following table.
| | |
---|
2000, 32 bit
| MS-Windows-2000\x86 | not available |
---|
XP, 32 bit | MS-Windows-XP\x86 | not available |
---|
XP, 64 bit | MS-Windows-XP\x64 | not available |
---|
Vista, 32 bit
| MS-Windows-Vista+7\x86 | not available |
---|
Vista, 64 bit | MS-Windows-Vista+7\x64 | not available |
---|
7, 32 bit
| MS-Windows-Vista+7\x86 | available |
---|
7, 64 bit
| MS-Windows-Vista+7\x64 | available |
---|
8, 32 bit
| MS-Windows-Vista+7\x86 | available |
---|
8, 64 bit | MS-Windows-Vista+7\x64 | available |
---|
|