Overview

The Trenz Electronic TE0729 is an industrial-grade SoM (System on Module) based on Xilinx Zynq-7000 SoC (XC7Z020).

This SoM has following peripherals on board:

• 1 x Gbps Ethernet Phy transceiver
• 2 x 100 Mbps Ethernet PHY transceivers
• 512 MByte DDR3 SDRAM
• 32 MByte Flash-Memory
• 4 Gbyte NAND-Flash-Memory
•  USB PHY transceiver
• powerful switch-mode power supplies for all on-board voltages
• large number of configurable I/Os is provided via rugged high-speed stacking strips

All modules in 4 x 5 cm form factor are mechanically compatible.

Block diagram

Board Components

Main Components:

Key Features

• Industrial-grade Xilinx Zynq-7000 (XC7Z020) SoM
• Rugged for shock and high vibration
• 2 x ARM Cortex-A9
• 1 x 10/100/1000 Gbps Ethernet transceiver PHY
• 2 x 10/100 Mbps Ethernet transceiver PHYs
• 3 x MAC-Address EEPROMs
• 16-Bit wide 512 MByte DDR3 SDRAM
• 32 MByte QSPI-Flash-Memory
• 4 GByte NAND-Flash-Memory (embedded eMMC Memory)
• Programmable Clock Generator
  • Transceiver Clock (default 125 MHz)
• USB 2.0 high-speed ULPI transceiver
• 4 GTP/GTX (high-performance transceiver) lanes
  • GTP/GTX (high-performance) clock input
• Plug-on module with 2 x 120-pin high-speed hermaphroditic strips
• 136 FPGA I/Os (58 LVDS pairs possible) and 6 PS MIO available on board-to-board connectors
• On-board high-efficiency DC-DC converters
  • 4.0 A x 1.0 V power rail
  • 1.5 A x 1.5 V power rail
  • 1.5 A x 1.8 V power rail
  • 1.5 A x 2.5 V power rail
• System management
• eFUSE bit-stream encryption
• AES bit-stream encryption
• Temperature compensated RTC (real-time clock)
• User LED
• Evenly-spread supply pins for good signal integrity

Assembly options for cost or performance optimization available upon request.

Signals, Interfaces and Pins

System Controller I/O Pins

Special purpose pins used by TE0729

Boot Modes

By default the TE-0729 supports QSPI-Flash-Memory, JTAG and SD-Card (if available on base board) boot modes.

The boot modes are controlled by the Pins 'BOOT1' and 'BOOT2'.