Overview

The Trenz Electronic TE0729 is an industrial-grade SoM (System on Module) based on Xilinx Zynq-7000 SoC (XC7Z020).

This SoM has following peripherals on board:

All modules in 4 x 5 cm form factor are mechanically compatible.

Block diagram

Board Components

Main Components:

Key Features

Assembly options for cost or performance optimization available upon request.

 

Signals, Interfaces and Pins

System Controller I/O Pins

Special purpose pins used by TE0729

NameNote
NRST 
NRST_IN 

Boot Modes

By default the TE-0729 supports QSPI-Flash-Memory, JTAG and SD-Card (if available on base board) boot modes.

The boot modes are controlled by the Pins 'BOOT1' and 'BOOT2' on the board to board (B2B) connector.

Pin-State

BOOTMODE1 / BOOTMODE2

boot mode
LOW / LOW 
LOW / HIGH 
HIGH / LOW 
HIGH / HIGH 

JTAG

JTAG access to the Xilinx Zynq-7000 device is provided by connector J2.

SignalB2B Pin
TCKJ2:  119
TDIJ2:  115
TDOJ2:  117
TMSJ2:  113
 
JTAGSEL pin in J2 should be kept low or grounded for normal operation.

 

Clocking

ClockFrequencyICFPGANotes
PS CLK33.3333 MHzU14PS_CLKPS Subsystem main clock
10/100/1000 Mbps ETH PHY reference25 MHzU10- 
USB PHY reference52 MHzU12- 

 

Processing System (PS) Peripherals

PeripheralICDesignatorPSMIONotes
EEPROM I2CU824AA025E48T-I/OTI2C0MIO10, MIO11MAC1-Adress
EEPROM I2CU924AA025E48T-I/OTI2C0MIO10, MIO11MAC2-Adress
EEPROM I2CU2024AA025E48T-I/OTI2C0MIO10, MIO11MAC3-Adress
RTC     
RTC Interrupt     
SPI Flash     
Clock PLL     
Ethernet     
USB     
LED     
USB Reset     

Ethernet

Reset

     

 

Default MIO mapping:

MIOConfigured asB2BNotes