In this section you must explain how to power on the board and run the Reference Design (test board) on the particular module. The main points must be mentioned are:
|
Table of Contents |
For more information regarding how to draw a diagram, Please refer to "Diagram Drawing Guidline" . |
|
Over MicroUSB (5V) possible.
|
There are no DIPs on TE0722. In case of TE0790 (XMOD) usage, see power supply section.
|
D2(red): User LED connected to MIO9
D6(green): User LED connected to G14
D7(green): 3.3V Power LED
|
JTAG and UART is possible over miro USB connector.
miroUSB UART is connected to PL IO (RX: Pin H13, TX: Pin H14).