In this section you must explain how to power on the board and run the Reference Design (test board) on the particular module. The main points must be mentioned are: |
Table of Contents |
Overview
Power supply
The input power supply must be mentioned. |
|
Single 5V power supply with minimum current capability of 2.5A is recommended to operate the board.
DIP-Switches and Push Buttons
Explain all DIP switches functionality |
|
There is a switch S1 which is connected to RESET signal which resets the system entirely.
Signal | Designator | B2B | Active Level |
---|
RESET | S1 | J2-7 | Active High |
|
There are no DIPs on TE0728. In case of TE0790 (XMOD) usage, see power supply section.
LEDs
Explain all user LEDs functionality and connection. |
|
There are three user LEDs which can be used for variant purposes.
Designator | Color | Connected to | B2B | Active Level | Note |
---|
D1-A | Red | MIO48 | J2-30 | Active high |
| D1-B | Yellow | MIO49 | J2-38 | Active high |
| D1-C | Green | MIO50 | J2-36 | Active high |
|
|
JTAG/UART
Explain JTAG or UART connection breifly. |
|
JTAG and UART is possible over miro USB connector.
miroUSB UART is connected to PL IO (RX: Pin H13, TX: Pin H14).
Reference Designs
In this Section you must refer to the Reference Design (Test board) for the particular module. For Example: TE0728 Reference Designs |
Notes
In this Section you must refer to the Resources Page for the particular module. For Example: TE0728 Resources |