In this section you must explain how to power on the board and run the Reference Design (test board) on the particular module. The main points must be mentioned are:

  • Overview of the board (point out the LEDs, Ethernets, Switches and etc on the board overview)
  • Explain Switches functionality
  • Explain user LEDs

  • Explain the UART connection

  • Refer to the Reference Design

    For more information regarding how to draw a diagram, Please refer to "Diagram Drawing Guidline" .



Table of Contents

Overview






Power supply


The input power supply must be mentioned.


Single 5V power supply with minimum current capability of 2.5A is recommended to operate the board.

DIP-Switches and Push Buttons


Explain all DIP switches functionality


There is a switch S1 which is connected to RESET signal which resets the system entirely.

Signal

DesignatorB2BActive Level

RESET

S1

J2-7

Active High


There are no DIPs on TE0728. In case of TE0790 (XMOD) usage, see power supply section.

Jumpers

DesignatorConnected toB2BNote
J4Boot_RJ2-11Open: QSPI
Short: SD Card




Explain all Jumpers functionality and connection.


LEDs


Explain all user LEDs functionality and connection.


There are three user LEDs which can be used for variant purposes.

DesignatorColorConnected toB2BActive LevelNote
D1-ARedMIO48J2-30Active high
D1-BYellowMIO49J2-38Active high
D1-CGreenMIO50J2-36Active high


JTAG/UART


Explain JTAG or UART connection breifly.


JTAG and UART is possible over miro USB connector.

miroUSB UART is connected to PL IO (RX: Pin H13, TX: Pin H14).

Reference Designs

In this Section you must refer to the Reference Design (Test board) for the particular module.

For Example: TE0728 Reference Designs

Notes

In this Section you must refer to the Resources Page for the particular module.

For Example: TE0728 Resources