In this section you must explain how to power on the board and run the Reference Design (test board) on the particular module. The main points must be mentioned are:
|
Table of Contents |
The input power supply must be mentioned. |
Single 5V power supply with minimum current capability of 2.5A is recommended to power on the board the board.
DIP-Switches and Push Buttons
Explain all DIP switches functionality. |
There is a switch S1 which is connected to RESET signal, it resets the system entirely.
|
There is no DIPs on TE0728. In case of TE0790 (XMOD) usage, see DIPs mode.
Explain all Jumpers functionality and connection. |
The Bootmode must be set to the SD card because the petalinux must be boot from SD card, In order to change the jumper setting to SD card zou should set the jumper to short circuit. |
|
Explain all user LEDs functionality and connections. |
There are three user LEDs which can be used for variant purposes.
|
Explain JTAG or UART connection breifly. |
JTAG and UART is possible over miro USB connector.
miroUSB UART is connected to PL IO (RX: Pin H13, TX: Pin H14).
In this Section you must refer to the Reference Design (Test board) for the particular module. For Example: TE0728 Reference Designs |
In this Section you must refer to the Resources Page for the particular module. For Example: TE0728 Resources |