In this section you must explain how to power on the board and run the Reference Design (test board) on the particular module. The main points must be mentioned are:
|
Table of Contents |
The input power supply must be mentioned. |
Single 5V power supply with minimum current capability of 2.5A is recommended to power on the board.
DIP-Switches and Push Buttons
Explain all DIP switches functionality. |
There is a switch (S1) which is connected to RESET signal, it resets the system entirely.
|
There is no DIPs on TE0728. In case of TE0790 (XMOD) usage, see DIPs mode.
Explain all Jumpers functionality and connection. |
|
Explain all user LEDs functionality and connections. |
There are three user LEDs which can be used for variant purposes.
|
Explain JTAG or UART connection breifly. |
JTAG and UART connections are available through mini USB connector.
|
In this Section you must refer to the Reference Design (Test board) for the particular module. For Example: TE0728 Reference Designs |
In this Section you must refer to the Resources Page for the particular module. For Example: TE0728 Resources |