In this section you must explain how to power on the board and run the Reference Design (test board) on the particular module. The main points must be mentioned are:

  • Overview of the board (point out the LEDs, Ethernets, Switches and etc on the board overview)
  • Explain Switches functionality
  • Explain user LEDs

  • Explain the UART connection

  • Refer to the Reference Design

    For more information regarding how to draw a diagram, Please refer to "Diagram Drawing Guidline" .



Table of Contents

Overview





  1. Barrel Jack Power Supply
  2. XMOD JTAG Adapter
  3. SD card holder
  4. Reset
  5. Boot mode Jumper
  6. LEDs (R,Y,G)
  7. Ethernet Socket

Power supply

The input power supply must be mentioned.

Single 5V power supply with minimum current capability of 2.5A is recommended to power on the board. 


DIP-Switches and Push Buttons

Explain all DIP switches functionality.

There is a switch (S1) which is connected to RESET signal, it resets the system entirely.

Signal

DesignatorB2BActive Level

RESET

S1

J2-7

Active High


There is no DIPs on TE0728. In case of TE0790 (XMOD) usage, see DIPs mode.

Jumpers

Explain all Jumpers functionality and connection.


DesignatorConnected toB2BNote
J4Boot_RJ2-11Open: QSPI
Short: SD Card


LEDs

Explain all user LEDs functionality and connections.

There are three user LEDs on the carrier TEB0728 which can be used for variant purposes.

DesignatorColorConnected toB2BActive LevelNote
D1-ARedMIO48J2-30Active high
D1-BYellowMIO49J2-38Active high
D1-CGreenMIO50J2-36Active high


Furthermore, there are two user LEDs on module TE0728.

DesignatorColorConnected toActive LevelNote
D4GreenBank33 pin V18Active high
D8RedMIO7Active high


JTAG/UART

Explain JTAG or UART connection breifly.

JTAG and UART connections are available through XMOD JTAG adapter. For more information refer to TE0790.

Designator

Connected to

B2B Pin

XMOD Header JB1DirectionNote
UART TxdMIO52J2-15JB1-3InputTransfer
UART Rxd MIO53J2-16JB1-7OutputReceive


Reference Designs

In this Section you must refer to the Reference Design (Test board) for the particular module.

For Example: TE0728 Reference Designs

Notes

In this Section you must refer to the Resources Page for the particular module.

For Example: TE0728 Resources