Template Revision 1.0 - on construction For carrier - module combination, create main getting started page for carrier Design Name always "TE Series Name" +Getting Started, for example "TE0701 Getting started" and add carrier/module combination in the description → link on the module resource page also For whole board, use the board name, for example "TEBF0911 Getting Started" |
In this section you must explain how to power on the board and run the Reference Design (test board) on the particular module. The main points must be mentioned are:
|
Table of Contents |
Basic instructions to work with TEI0022.
Functionality of buttons, DIP switches, LEDs depends on CPLD Firmware. |
Number | Note | Number | Note |
---|---|---|---|
1 | 15 | ||
2 | 16 | ||
3 | 17 | ||
4 | 18 | ||
5 | 19 | ||
6 | 20 | ||
7 | 21 | ||
8 | 22 | ||
9 | 23 | ||
10 | 24 | ||
11 | 25 | ||
12 | 26 | ||
13 | 27 | ||
14 | 28 |
The input power supply must be mentioned. |
Single ??V power supply with minimum current capability of ??A is recommended to power on the board.
Explain all DIP switches functionality. |
There is a switch (S??) which is connected to RESET signal, it resets the system entirely.
|
There is no DIPs on TExxxx. In case of TE0790 (XMOD) usage, see DIPs mode.
Explain all Jumpers functionality and connection. |
|
Explain all user LEDs functionality and connections. |
There are three user LEDs which can be used for variant purposes.
|
|
|
Explain JTAG or UART connection breifly. |
JTAG and UART connections are available through mini USB connector.
|
In this Section you must refer to the Reference Design (Test board) for the particular module. For Example: TE0728 Reference Designs |
In this Section you must refer to the Resources Page for the particular module. For Example: TE0728 Resources |