You are viewing an old version of this page. View the current version.
Compare with Current
View Page History
« Previous
Version 5
Next »
If the USB microcontroller (Cypress EZ-ESB FX2) TE USB FX2 driver is not installed on the host computer, then the easiest way to do it, is the following:
- disconnect the module if it connected or leave the module unconnected;
- turn off the TE USB FX2 module;
- set “EEPROM” switch to EEPROM connection enabled (EEPROM disconnected from USB microcontroller) (1);
- turn on the TE USB FX2 module;
- connect the module to the host computer through the USB interface;
- wait until the operating system detects new hardware and starts the hardware assistant;
![](/download/attachments/3834297/Device%20Manager_TEUnknow.png?version=1&modificationDate=1376559837000&api=v2)
- answer the hardware assistant questions as shown in the following document;
- Check that, in the “Device Manager” under “Trenz Electronic USB devices”, the “Trenz Electronic USB FX2” has been added.
![devmgmt-gen3.png](/plugins/servlet/confluence/placeholder/unknown-attachment?locale=en_GB&version=2)
(1) Refer to your module manual for switch location.