Table of Contents
TEF1002
Overview
Board Overview
- 4x5 module connectors
- Jumper J4 (VCCIOA)
- Jumper J7 (VCCA_SD)
- Dip swiches S2 and S3
- 6-pin PCI-E ATX Power Connector
- micro USB connector for FTDI USB to JTAG/UART bridge
- Push button
- Power LED
- Status LED
- top load microSD card cage
- Select Voltage VCCA_SD of 4x5 module bank where SD-Card is connected by Jumper J7 (1-2 →3.3V; 2-3 1.8V). Compare TRM of actually used 4x5 module.
- Select VCCIOA Voltage by setting J4 (1-2 →3.3V; 2-3 1.8V). If both FFA and FFB are not used any setting is ok. Do not leave open (communication of 4x5 module with TEF1002 CPLD is only possible with availabe VCCIOA)!
Dip Setting Note S1 Push button configured as reset S2-1
OFF FMC _VADJ OFF. The choice OFF, ON, OFF selects 1.8V FMC_VADJ, wich is a valid bank power for TE0720.
S2-2 OFF S2-3 OFF S2-4 ON Selects 4x5 module SOC/FPGA JTAG S2-5 ON S2-6 OFF S2-7 ON Module power enable. S2-8 ON Use extended power sequenzing. S3-1 OFF/ON For Zynq modules: Primary Boot Mode SD/QSPI. S3-2 OFF ON for TE0720 (overide automatic enable FMC__VADJ). For TE0720 bank bank 34 has to be powerded to start up. Therefore FMC VADJ has to be set to a valid value e.g. 1.8V - Connect 12V ATX connector
- Connect mico USB J10 to PC
- Use Xilinx JTAG tools to programm FPGA or for Zynq modules use micro SD Card.
- Use e.g. Putty on PC to check for UART interactions.
Power supply
Single 12V power supply with minimum current capability of 3A is recommended to power on the board via the 6-pin PCI-E ATX connector.
DIP-Switches and Push Buttons
Select dip switch settings according to the attached 4x5 module and your needs.
Compare Dip switch setting with TRM of your module and table in TRM of TEF1002
Signal | Designator | B2B | Active Level |
---|---|---|---|
DIP Switches /Push Buttons
Jumpers
Designator | Connected to | B2B | Note |
---|---|---|---|
Boot_R | Open: | ||
Short: |
Jumpers
LEDs
There are three user LEDs which can be used for variant purposes.
Designator | Color | Connected to | B2B | Active Level | Note |
---|---|---|---|---|---|
Carrier LEDs
Designator | Color | Connected to | Active Level | Note |
---|---|---|---|---|
Module LEDs
Designator | Color | Connected to | Active Level | Note |
---|---|---|---|---|
Carrier LEDs
JTAG/UART
JTAG and UART connections are available through mini USB connector.
JTAG(first FTDI port) and UART(second FTDI port) is over MicroUSB connector possible. External JTAG Programmer is not needed.
Designator | Connected to | B2B Pin | XMOD Header JB? | Direction | Note |
---|---|---|---|---|---|
UART
Reference Designs
Notes
Overview
Content Tools