Page History
...
- Connect MiniUSB cable to XMOD
- Set DIP Switch S1-2 to OFF position, see TE0706 TRM#4-bitDIP-switch
- Power ON the board
- Run "Lattice Diamond Programmer"
Select "Create new project from JTAG chain" and press "OK"
Available CPLD Firmware
- TE0823 CPLD - Firmware description with different Variants for PCB REV03 and newer
- QSPI / SD Boot Modi - Default delivered, QSPI or SD Boot Mode is selectable (Special FSBL for QSPI Programming with Boot Mode /= JTAG will be provided for Vivado 2017.4 Reference Design and newer).
- QSPI / JTAG Boot Modi - Use QSPI or JTAG Boot Mode is selectable
- JTAG / SD Boot Modi - SD or JTAG Boot Mode is selectable
- JTAG / QSPI / SD Boot Modi - QSPI, SD or JTAG Boot Mode is selectable (CPLD Pin 23 (NOSEQ) is used as second Boot Mode pin to select JTAG Boot Mode). Attention: This need 7 Series 4x5 Carrier CPLD Firmware update.
Download
- TE0823/<PCB Revision>/Firmware/
- Use files from the subfolders of your PCB revision
...
Overview
Content Tools