• Last modified: Apr 23, 2019

Table of Contents

TEB0728 with TE0728

Overview

Board Overview
  1. Barrel Jack Power Supply
  2. XMOD JTAG Adapter
  3. SD card holder
  4. Reset
  5. Boot mode Jumper
  6. Carrier LEDs (Red,Yellow,Green) D1
  7. Ethernet Socket
  8. Module LEDs (Green D4, Red D8)

Power supply

Single 5V power supply with minimum current capability of 2.5A is recommended to power on the board. 

Overview 1

Supply VoltageMin CurrentNote

J9

5 V

2.5 A


Power Supply

DIP-Switches and Push Buttons

There is a switch (S1) which is connected to RESET signal, it resets the system entirely.

Overview 4

Connected toB2BActive Level

S1

RESET

J2-7

Active High
DIP Switches /Push Buttons

There is no DIPs on TE0728. In case of TE0790 (XMOD) usage, see DIPs mode.

Jumpers

Overview 5Connected toB2BNote
J4Boot_RJ2-11Open: QSPI
Short: SD Card
Jumpers

LEDs

There are three user LEDs on the carrier TEB0728 which can be used for variant purposes.

Overview 6ColorConnected toB2BActive LevelNote
D1-ARedMIO48J2-30Active highUser LED
D1-BYellowMIO49J2-38Active highUser LED
D1-CGreenMIO50J2-36Active highUser LED
Carrier LEDs

Furthermore, there are two user LEDs on module TE0728.

Overview 8ColorConnected toB2BActive LevelNote
D4GreenBank33 pin V18-Active highUser LED
D9GreenDONE_0

DONE pin
D8RedMIO7-Active highUser LED
Module LEDs

JTAG/UART

JTAG and UART connections are available through XMOD JTAG adapter. For more information refer to TE0790.

DIP Switch on the XMOD JTAG adapter must be set  like the following table.

Overview 2DIP SwitchSetting
JB11ON
2OFF
3OFF
4ON
XMOD JTAG DIP Switch

Reference Designs

Notes