...
Scroll pdf title | ||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||||||||||
SPI signal details (bank 2). |
Warning |
---|
SPI pins on B2B connector J5 cannot be used as GPIOs (general purpose I/Os). |
SPI signals are made available on the dedicated header J3 accessible through an SPI programmer with flying leads as described in the table below.
...
). |
...
SPI /S
...
...
SPI D
...
SPI Q
...
SPI /C
...
GND
...
Vref (3.3 V)
...
The SPI bus can be used during configuration and operation in a plurality of ways as summarized respectively in Table A (SPI bus for configuration) and Table B (SPI bus for operation).
Warning |
---|
Any other usage of the SPI bus is neither supported nor recommended. |
The SPI bus is used for configuration in two ways by default:
...
In case (a), the FPGA shall be turned off to release its shared SPI pins.
In case (b), the USB FX2 microcontroller shall three-state (Z = high impedance) its shared SPI pins.
Scroll pdf title | ||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||||||||||||||
|
The PROM file (containing the FPGA configuration bitstream) can be written to the SPI serial Flash memory (slave) also through the SPI pins of B2B connector J5 (attached device set to master mode). In this case, the FPGA shall be turned off or three-stated to release its shared SPI pins and the USB FX2 microcontroller shall three-state (Z = high impedance) its shared SPI pins.
A plurality of usage combinations of the SPI bus during operation is made available to the user as suggested in Table B below.
Scroll pdf title | ||||||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||||||||||||||||||||||||||||
|
Warning |
---|
Other combinations of master and slave units are neither supported nor recommended. |
SPI signals are made available on the dedicated header J3 accessible through an SPI programmer with flying leads as described in the table below.
Scroll pdf title | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||
|