Note | ||
---|---|---|
| ||
The (generation 2)TE USB FX2 driver should be already installed and a Generation 2 firmware should be already programmed in USB FX2 microcontroller's EEPROM and RAM. |
...
An update boot (aka TE USB FX2 firmware update) is a multi-step boot operation:
...
NOTE: the procedeure are the same of this link but with Dewesoft vid/pid /vid (current_dw.iic) in place of Trenz Electronic vid/pid (currente_te.iic).
An FPGA Configuration (aka TE USB FX2 SPI and FPGA programming) is a multi-step operation:
Insert the TE USB FX2 module with the USB EEPROM enabled (when TE USB FX2 module is powered on).
Open a USB Firmware Upgrade Tool
(double click ofut.py
). Case B is considered true from now on: TE USB FX2 module is seen under Device Driver as a Trenz Electronic Device.