Versions Compared

Old Version 12

changes.mady.by.user Ali Naseri

Saved on

compared with

New Version 13

changes.mady.by.user Ali Naseri

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

MPSSE - FTDI protocol that is used by JTAG and SPI adapters based on FTDI devices.

Warning

Important notice on TE0790-xx variants:

Do not access the FT2232H EEPROM using FTDI programming tools, doing so will erase normally invisible user EEPROM content and invalidate stored Xilinx JTAG license. Without this license the on-board JTAG will not be accessible any more with any Xilinx tools. Software tools from FTDI website do not warn or ask for confirmation before erasing user EEPROM content.

Key Features

  • Xmod form-factor
    • size: 20 x 25 mm
    • M3 mounting hole
  • FT2232H
    • USB2.0 port High Speed (480 Mbps) and Full Speed (12 Mbps) compatible
    • Entire USB protocol handled on the chip
    • USB2.0 to JTAG, SPI and I²C conversion provided by the IC's Multi-Protocol Synchronous Serial Engine (MPSSE)
    • USB2.0 to UART conversion
    • Channel B UART RX/TX LED's
    • Mini-USB B connector (more rigid then micro-USB)
    • 93C56 EEPROM
  • Lattice XO2-256 CPLD
    • on board programmable using Lattice tools
    • 8 universal I/O pins
    • VCCIO either 3.3V or user supplied (1.8 to 3.3V)
    • RED user LED
    • 12 MHz clock from on-board Oscillator
  • LDO DCDC for optional USB power
  • GREEN Power-on LED
  • User button
  • 4 position DIP switch
    • Choose CPLD program mode
    • FTDI EEPROM disable (not implemented in PCB REV 1)
    • Use VIO same as VCC
    • Use VCC from USB

...

Warning

Important notice on TE0790-xx variants:

Do not access the FT2232H EEPROM using FTDI programming tools, doing so will erase normally invisible user EEPROM content and invalidate stored Xilinx JTAG license. Without this license the on-board JTAG will not be accessible any more with any Xilinx tools. Software tools from FTDI website do not warn or ask for confirmation before erasing user EEPROM content.The Configuration EEPROM of TE0790-xxL variants are capable of being programmed with FTDI-Tools.

System Controller CPLD

The System Controller CPLD (U1) is provided by Lattice Semiconductor LCMXO2-256HC (MachXO2 Product Family). The  SC-CPLD is the central system management unit where essential control signals are logically linked by the implemented logic in CPLD firmware, which generates output signals to control the system, the on-board peripherals and the interfaces.

...