Page History

...

Table x: .

On-board Peripherals

DDR Memory

TE0723 module has up to 512-MBytes of DDR3L SDRAM arranged into 32-bit wide memory bus providing total of 1 GBytes of on-board RAM. Different memory sizes are available optionally.

Quad SPI Flash Memory

On-board quad SPI Flash memory S25FL127S (U5) is used to store initial FPGA configuration. Besides FPGA configuration, remaining free flash memory can be used for user application storage. All four SPI data lines are connected to the Zynq SoC's PS, allowing x1, x2 or x4 data bus widths. Maximum data rate depends on the bus width and clock frequency used.

Dual High Speed USB to Multipurpose UART/FIFO

FT2232H...

High-speed USB ULPI PHY

Hi-speed USB ULPI PHY (U18) is provided with USB3320 from Microchip. The ULPI interface is connected to the Zynq SoC's PS USB0 via MIO28..39, bank 501 (see also section). The I/O voltage is fixed at 3.3V and PHY reference clock input is supplied from the on-board 52.000000 MHz oscillator (U14).

High-Speed CMOS Logic Analog Multiplexer

Digitally controlled analog switch TI CD74HC4051...

Low-power Operational Amplifier

The Microchip Technology Inc. MCP6001...

Oscillators

The module has following reference clock signals provided by on-board oscillators:

...