Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

FunctionMGT LaneSchematic Names / B2B pinsRequired Ref ClockClock SourceComment
PCIePS 0

PCI_TX_N, pin J2-67
PCI_TX_P, pin J2-69

PCI_RX_N, pin J2-70
PCI_RX_P, pin J2-72

100 MHzclock signal of SoM's prog. PLL

single lane PCIe connector

clock signal routed on carrier board to PCIe connector J1

USB3PS 1

USB3_TXUP_N, pin J2-61
USB3_TXUP_P, pin J2-63

USB3_RXUP_N, pin J2-64
USB3_RXUP_P, pin J2-66

100 MHzclock signal of SoM's prog. PLL

clock signal routed on-module,
also optional Optional (not equipped) 100 MHz osci. U35 configurable. U6 is possible (Configurable on Zynq PS).

SATAPS 2

SATA_TX_N, pin J2-55
SATA_TX_P, pin J2-57

SATA_RX_N, pin J2-58
SATA_RX_P, pin J2-60

150 MHzOn-board oscillator U23

optional: clock signal of SoM's prog. PLL

DP.0PS 3

DP0_TX_N, pin J2-49
DP0_TX_P, pin J2-51

27 MHzclock signal of SoM's prog. PLL

DisplayPort GT SERDES clock signal,
routed on-module to MGT bank

...

Following diagram visualizes the connection of the DC-DC converter control signals ('Enable', 'Power-Good') with System Controller CPLD U39, which enables the particular on-board voltages.

 


Figure 13: Power-On Sequence Utilizing DCDC Converter Control Signals

...

 Date

Revision

ContributorsDescription

Page info
modified-date
modified-date
dateFormatyyyy-MM-dd

John Hartfiel
  • Typo correction Table 13
  • Typo correction Table 9
2017-11-15v.86Ali Naseri
  • DIP-switches section revised and updated

2017-11-13

v.82

Ali Naseri
  • updated B2B connector max. current rating
    per pin

2017-11-13

v.80

John Hartfiel
  • rework B2B section
2017-10-19

v.79

Ali Naseri
  • added additionally MGT lanes information

2017-10-18

v.75
Ali Naseri
  • added Power Rails section

2017-08-29

v.70



John Hartfiel
  • update document change history
  • published
2017-08-28v.69Ali Naseri
  • Initial document

...