Versions Compared

Old Version 4

changes.mady.by.user John Hartfiel

Saved on

compared with

New Version 5

changes.mady.by.user John Hartfiel

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Page properties
hiddentrue
idComments

In this section you must explain how to power on the board and run the Reference Design (test board) on the particular module. The main points must be mentioned are:

  • Overview of the board (point out the LEDs, Ethernets, Switches and etc on the board overview)
  • Explain Switches functionality
  • Explain user LEDs

  • Explain the UART connection

  • Refer to the Reference Design

    Note

    For more information regarding how to draw a diagram, Please refer to "Diagram Drawing GuidlineGuideline" .



Scroll pdf ignore

Table of Contents

Table of Contents

...

Scroll Title
anchorFigure_Overview
titleBoard Overview


Scroll Ignore
scroll-pdftrue
scroll-officetrue
scroll-chmtrue
scroll-docbooktrue
scroll-eclipsehelptrue
scroll-epubtrue
scroll-htmltrue

draw.io Diagram
borderfalse
viewerToolbartrue
fitWindowfalse
diagramDisplayName
lboxtrue
revision23
diagramNameTEBF0808_getting_started_overview
simpleViewertrue
width
linksauto
tbstyletop
diagramWidth641


Scroll Only


  1. Reset Button S2
  2. LEDs D7 Red (Usage: status) and D6 Green (Usage: status)
  3. Reset Button S1
  4. Power Jack 2.1mm (optional 12V power input)
  5. S5 DIP for Boot Mode and FMCVADJ
  6. Enclosure Pin header(Reset and Power Button, HD LED (Usage: status/user) and Power LED (Usage: status/user))
  7. S4 DIP for CPLD access and power control
  8. XMOD J12 with green dot for Module JTAG and UART, XMOD LED D4 Red used  for status information
  9. XMOD J28 for CPLD,FMC JTAG and Firmware ID over UART(need CPLD Firmware 7 or newer) , XMOD LED D4 Red used for status information
  10. FPGA Done LED (location varies slightly depending on module)
  11. ATX Power Connector (Main 12V and 5V Power supply), recommended power supply connector
  12. SFP LED D1 Red
  13. SFP LED D8 Green
  14. SFP LED D9 Red
  15. SFP LED D10 Green
  16. ETH LED Yellow
  17. ETH LED Green/Orange
  18. LEDs D4 Green (Usage: status/user) and D5 Red (Usage: status/user)

Power supply

Page properties
hiddentrue
idComments

The input power supply must be mentioned. Add Link to overview picture with connector label.

...