You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 5 Next »

Table of Contents

TEBF0808 with TE080x

Overview

Board Overview
  1. Reset Button S2
  2. LEDs D7 Red (Usage: status) and D6 Green (Usage: status)
  3. Reset Button S1
  4. Power Jack 2.1mm (optional 12V power input)
  5. S5 DIP for Boot Mode and FMCVADJ
  6. Enclosure Pin header(Reset and Power Button, HD LED (Usage: status/user) and Power LED (Usage: status/user))
  7. S4 DIP for CPLD access and power control
  8. XMOD J12 with green dot for Module JTAG and UART, XMOD LED D4 Red used  for status information
  9. XMOD J28 for CPLD,FMC JTAG and Firmware ID over UART(need CPLD Firmware 7 or newer) , XMOD LED D4 Red used for status information
  10. FPGA Done LED (location varies slightly depending on module)
  11. ATX Power Connector (Main 12V and 5V Power supply), recommended power supply connector
  12. SFP LED D1 Red
  13. SFP LED D8 Green
  14. SFP LED D9 Red
  15. SFP LED D10 Green
  16. ETH LED Yellow
  17. ETH LED Green/Orange
  18. LEDs D4 Green (Usage: status/user) and D5 Red (Usage: status/user)

Power supply


DIP-Switches and Push Buttons


DIP Switches /Push Buttons


Jumpers

Jumpers

LEDs


Carrier LEDs

Furthermore, there are two user LEDs on module TE0728.

DesignatorColorConnected toNote
D1RedDONE signal (PS Configuration Bank 503)

This LED goes ON when power has been applied to the module and stays ON until MPSoC's programmable logic is configured properly.

Module LEDs

JTAG/UART

SoC JTAG and UART connections are available through XMOD JTAG adapter with the green dot on J12. For more information refer to TE0790.

DIP Switch on the XMOD JTAG adapter must be set like the following table.

DIP SwitchSetting
1ON
2OFF
3OFF
4OFF
XMOD JTAG DIP Switch. Attention: Never changes the default setting

Reference Designs

Notes

Module and Carrier are also as starter kit available:


  • No labels