Versions Compared

Old Version 5

changes.mady.by.user Pedram Babakhani

Saved on

compared with

New Version 6

changes.mady.by.user Pedram Babakhani

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.


Page properties
hiddentrue
idComments

In this section you must explain how to power on the board and run the Reference Design (test board) on the particular module. The main points must be mentioned are:

  • Overview of the board (point out the LEDs, Ethernets, Switches and etc on the board overview)
  • Explain Switches functionality
  • Explain user LEDs
  • Explain the UART connection
  • Refer to the Reference Design


Scroll pdf ignore

Table of Contents

Table of Contents

Overview

Note

For more information regarding how to draw a diagram, Please refer to "Diagram Drawing Guidline" .


Scroll Title
anchorFigure_anchorname
titleModule Overview


Scroll Ignore



Scroll Only




Power supply

Page properties
hiddentrue
idComments


Note

The input power supply must be mentioned.


Over MicroUSB (5V) possible.

DIP-Switches

Page properties
hiddentrue
idComments


Note

Explain all DIP switches functionality


There are no DIPs on TE0722. In case of TE0790 (XMOD) usage, see power supply section.

LEDs

Page properties
hiddentrue
idComments


Note

Explain all user LEDs functionality and connection.


D2(red): User LED connected to MIO9

D6(green): User LED connected to G14

D7(green): 3.3V Power LED

JTAG/UART

Page properties
hiddentrue
idComments


Note

Explain JTAG or UART connection breifly.


JTAG and UART is possible over miro USB connector.

miroUSB UART is connected to PL IO (RX: Pin H13, TX: Pin H14).

Reference Designs

Notes