Page History
...
- Close all Xilinx Programs
- Power off TE0722
- Bridge S25FL127S Pin 7 temporary with GND to change Boot Mode to JTAG Bode Mode only (See picture).
- Power on TE0722
- Disconnect the GND bridge wire from Pin 7
- Open SDK
- Program Flash with valid Boot.Bin, if programming failed try again from step 1.
...
Changing bootmode
The easiest way to change the Bootmode pinstrap is temporary connection of SPI Flash Pin 7 to Ground. This pin connected with Pullup-Resistor to 3.3V, to set FPGA in Quad-SPI Mode. Shorting this Pin with GND will enable JTAG Boot Mode.
...
Overview
Content Tools