Page History
...
Note |
---|
For all Starter Kit's shipped before 2017-06-21: Enclosure Power and HD LED was swapped on connector. See See "Starter Kit Cable Connection - Enclosure Power Button, Reset Button, HDD LED and Power LED" section for correct connection. |
...
Power Button , Reset Button, HDD LED and Power LED Enclosure Location
Default DIP Switch Settings
Warning |
---|
Do not change XMOD DIP-Switch settings on TEBF0808. Do not swap the XMOD adapters the one marked with green dot must be closer to the SoM |
...
For more information, see:TEBF0808
Starter Kit Status
- Section is currently not complete -
Main Power Switch is OFF
No Power on Starter Kit.
Identification: FANs do not work, all LEDs are off.
Main Power Switch is ON and Power Button is not pressed
Only some basics on TEBF0808 are powered on. This mode is used for CPLDs Firmware updates.
Identification: FANs do not work, some LEDs blinking.
LED description:
Main Power Switch is ON and Power Button is pressed first time
TE0808 will be powered on. System boots if boot mode is set correct and files are available.
Identification: FANs do work, LEDs blinking states change.
LED description:
Notes
Most LEDs are CPLD Firmware dependents, see TEBF0808 Master CPLD and TEBF0808 Slave CPLD
Starter Kit Cable Connection
...