Page History
...
Figure 3: Module power distribution diagram.
Power-On Sequence
Figure 4: TE0820-02 power-on sequence diagram.
For highest efficiency of on board DC-DC regulators, it is recommended to use same 3.3V power source for both VIN and 3.3VIN power rails. Although VIN and 3.3VIN can be powered up in any order, it is recommended to power them up simultaneously.
...
All dimensions are given in millimeters.
Figure 45: TE0715 physical dimensions.
...
Hardware revision number is printed on the PCB board together with the module model number separated by the dash.
Figure 56: TE0715 hardware revision number.
...
Date | Revision | Contributors | Description | ||||||||
---|---|---|---|---|---|---|---|---|---|---|---|
| Jan Kumann |
| |||||||||
2017-06-07 | v.64 | Jan Kumann | Minor formatting. | ||||||||
2017-03-02 | v.59 | Thorsten Trenz | Corrected boot mode table. | ||||||||
2017-02-10 | v.58 | Thorsten Trenz | Corrected PLL initial delivery state. | ||||||||
2017-01-25 | v.55
| Jan Kumann | New block diagram. | ||||||||
2017-01-14 | v.50 | Jan Kumann |
| ||||||||
2016-11-15 | v.45 | Thorsten Trenz | Added B2B Connector section. | ||||||||
2016-10-18 | v.40 | Ali Naseri | Added table "power rails". | ||||||||
2016-06-28 | v.38
| Thorsten Trenz, Emmanuel Vassilakis, Jan Kumann |
| ||||||||
2016-04-27 | v.33 | Thorsten Trenz, Emmanuel Vassilakis |
| ||||||||
2016-03-31 | v.10 | Philipp Bernhardt, Antti Lukats | Initial version. |
...