Page History
...
Storage Device Name | Content | Notes |
---|---|---|
24AA025E48 EEPROM | User content, not programmed | Valid MAC Address from manufacturer. |
SPI Flash OTP Area | Empty, not programmed | Except serial number programmed by flash vendor. |
SPI Flash Quad Enable bit | Programmed | - |
SPI Flash main array | Demo designNot programmed | - |
eFUSE USER | Not programmed | - |
eFUSE Security | Not programmed | - |
Si5338 OTP NVM | Default settings pre Not programmed | OTP not re-programmable after delivery from factory |
...
TE0745 module supports different boot modes which are configurable by the control line 'BOOTMODE' and 'BOOTMODE_1'. The line 'BOOTMODE' is available on B2B connector pin J2-133, the line 'BOOTMODE_1' is connected to the System Controller CPLD on bank 1, pin 21 (permanent logic high in standard SC-CPLD firmware).The boot mode selection will be set by the Zynq's PS MIO pins MIO3...MIO5.
...
Boot Mode | MIO5 (BOOTMODE_1), SC CPLD | MIO4 (BOOTMODE), J2-133MIO3 | Note | |
---|---|---|---|---|
JTAG | 0 | 0 | 0 | - |
NOR | 0 | 0 | 1 | MIO3 pin is shared with QSPI Flash Memory (QSPI-DQ1). |
01 | 0 | - | ||
QSPI Flash Memory | 1 | 0 | 0 | standard mode in current configuration. |
SD-Card | 1 | 1 | 0 | SD-Card on base board necessary. |
...
In delivery state of the SoM the boot mode depends on the configured SC-CPLD firmware. The current mode Basically MIO5 is set to boot from the QSPI Flash Memory1 and JTAG is in cascade.
On-board Peripherals
System Controller CPLD
...
Bank | Schematic Name | Voltage | Voltage Range |
---|---|---|---|
0 (config) | VCCIO_0 | PL_1.8V, if R67 is equipped | - |
500 (MIO0) | PS_1.8V | 1.8V | - |
501 (MIO1) | PS_1.8V | 1.8V | - |
502 (DDR3) | 1.35V | 1.35V | - |
12 HR | VCCIO_12 | User | HR: 1.2V to 3.3V |
13 HR | VCCIO_13 | User | HR: 1.2V to 3.3V |
33 HP | VCCIO_33 | User | HP: 1.2V to 1.8V |
34 HP | VCCIO_34 | User | HP: 1.2V to 1.8V |
35 HP | VCCIO_35 | User | HP: 1.2V to 1.8V |
...
Date | Revision | Contributors | Description | ||||||||
---|---|---|---|---|---|---|---|---|---|---|---|
| Ali Naseri, Jan Kumann, John Hartfiel |
|
Table 24: Document change history.
...