Page History
...
The boot device is selected by the mode jumpers on pin header J6. Placing a jumper at pin 13-14 sets Mode0 to low level. Mode1 is set to low level by jumper on over pin 15-16. Boot modes are further described at the corresponding section of the modules, e.g. Table 2, Boot mode selection of TE0724 TRM. Default with no jumpers is boot from SD-Card.
...
Date | Revision | Contributors | Description | ||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
|
|
| ||||||||||||||||||||||||||
| v.26 | Martin Rohrmüller |
| |||||||||||||||||||||||||||
| v.25 | Martin Rohrmüller |
| |||||||||||||||||||||||||||
| v.24 | Martin Rohrmüller |
| |||||||||||||||||||||||||||
v.23 | John Hartfiel |
| |||||||||||||||||||||||||||
2018-07-10 | v.19 |
|
...
Overview
Content Tools