The Trenz Electronic TEC0850 board is a CompactPCI Serial card (3U form factor) integrating a Xilinx Zynq UltraScale+ MPSoC, one DDR4 SDRAM SODIMM socket with 64bit wide data bus, max. dual 512 MByte Flash memory for configuration and operation, 24 Gigabit transceivers on PL side and 4 on PS side, powerful switch-mode power supplies for all onboard voltages, USB2 and USB3 FIFO bridges and a large number of configurable I/Os available on the CompactPCI Serial backplane connectors.
Refer to http://trenz.org/tec0850-info for the current online version of this manual and other available documentation.
...
Zynq UltraScale+ MPSoC ZU15
Front side interface connectors
RJ-45 GbE Ethernet interface
Circular push/pull connector with 4x on-board 8bit DAC output
MicroSD Card connector
USB 2.0 and USB 3.0 to FIFO bridge connector
4x status LEDs
4 CompactPCI Serial connectors for backplane connection (3U form factor)
24 GTH lanes
4 PS GTR lanes
USB 2.0 interface
64 Zynq PL HP I/O's
8x PLL clock input
JTAG, I²C and 7 user I/O's to MAX10 FPGA
64bit DDR4 SODIMM (PS connected), 8 GByte maximum
Dual parallel QSPI Flash (bootable), 512 MByte maximum
26-pin header with 20 Zynq PL HD I/O's
3-pin header with 2 MAX10 FPGA I/O's
System Controller (Altera MAX10 FPGA SoC)
Power Sequencing
System management and control for MPSoC and onboard peripherals
Si5345 programmable 10 output PLL clock generator
Si53340 Quad clock buffer
2x 4bit DIP switches
1x user push button
Zynq MPSoC cooling FAN connector
On-board high-efficiency DC-DC converters
...
Page properties
hidden
true
id
Comments
Notes :
For carrier or stand-alone boards use subsection for every connector type (add designator on a description, not on the subsection title), for example:
SD
USB
ETH
FMC
...
For modules which need carrier us only classes and refer to B2B connector if more than one is used, for example
JTAG
UART
I2C
MGT
...
CompactPCI Serial Backplane Connectors
The TEC0850 board is equipped with 3 CompactPCI CompactPCI Serial high-speed backplane connectors which provide serial high-speed interconnects with transmission rates up to 12 Gb/s to the Zynq MPSoCs MGT lanes. On the cPCI connectors are also available single-ended Zynq MPSoC PL HP I/O's, high-speed USB 2.0 interface and single-ended I/O's of the System Controller FPGA.
...
Following diagram gives an overview of the CompactPCI Serial backplane connectors and their connections to the Zynq Ultrascale+ MPSoC and the System Controller FPGA U18:
...
Following tables contains information about the interfaces, I/O's, clock and VCCIO sources available on the cPCI connectors:
CompactPCI Serial connector J3 is not fitted on the TEC0850 board by default, but is necessary if the second optional USB2 PHY U13 if fitted and its USB2 differential serial data interface is connected to the cPCI connector J2.