Versions Compared

Old Version 26

changes.mady.by.user John Hartfiel

Saved on

compared with

New Version 27

changes.mady.by.user John Hartfiel

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

S3-3 (SC_SW1)S3-4 (SC_SW2)Description
OFFOFFSD1 Boot Mode (SD-Card on J11), if SD is insered
OFFOFFeMMC Boot Mode, if SD is not insered
OFFONPJTAG0
ONOFFQSPI32
ONONJTAG

...

LEDDescription
LED4 (D16 red)

User FPGA IO B67_T3

LED3 (D15 green)User FPGA IO B67_T2
LED2 (D14 green)

PS Status. Status depends on blink sequence and priority.

  1. ********    : Reset button is pressed
  2. *****ooo   : Init_B failed
  3. ****oooo   : PS_Error_Status and PS_Error failed
  4. ***ooooo   : PS_Error_Status failed
  5. **oooooo  : PS_Error failed
  6. *ooooooo  : Done is low-> SoC PL not programmed
  7. LED OFF or ON :  user defined from MIO30
LED4 (D13 green)Power LED. Status depends on blink sequence and priority.
  1. LED ON  OFF: Power button is pressed (Note, 1 and 8 are swapped with CPLD REV03)
  2. ********    : Main power up failed
  3. *****ooo   : Main power error after successfully startup
  4. *****ooo   : MGT or Periphery power up failed
  5. ***ooooo  : MGT or Periphery power error after successfully startup
  6. **oooooo  : FMC power up failed
  7. *ooooooo : FMC power error after successfully startup
  8. LED OFF ON: Power good (Note, 1 and 8 are swapped with CPLD REV03)
FPGA XMOD (J24-XMOD2)

Boot Mode. Status depends on blink sequence and priority.

  1. LED ON  : JTAG
  2. ********    : Error unknown state
  3. *****ooo   : not used
  4. *****ooo   : not used
  5. ***ooooo  : not used
  6. **oooooo  : QSPI
  7. *ooooooo : PJTAG_0
  8. LED OFF : SD1
CPLD XMOD (J35-XMOD1)
  1. ********    : one or more of FMCx_PG_M2C of connected FMC are not ready
  2. LED OFF : all connected FMCx_PG_M2C are ready
ETH LED Left (Green/Orange)

OFF, if Main Power Failed otherwise PHY_LED0(depends on PHY Configuration)

  • Green, if FAN1...3 enabled and FMC FAN with connected modules are enabled
  • Orange, if one of FAN1..3 or FMC FAN wirg connected modules are disabled
ETH LED Right (Yellow)OFF, if Main Power Failed otherwise PHY_LED1(depends on PHY Configuration)

...

  • add main Reset to optional User Button 3 (only on PCB REV04 usable)
  • add PHY LEDs
  • add emmC Boot Mode
  • new I2C controller
  • swapped LED1 0,7 state (LED ON is ready now)

CPLD REV01 to REV02

  • Correction of FAN_A_EN and FAN_AF_EN Location constrains

  • Add Pullup attribute to FMCX_PRSNT signals

  • I2C Enable mapping is changed

...