Page History

An update boot  (aka TE USB FX2 firmware update), for Generation 3 firmware, is a multi-step boot operation:

• follow the same procedure of TE USB FX2

...

• driver installation (Generation 3);

• check that EEPROM connection is enabled (EEPROM switch is set in a way to enable EPPROM connection to USB FX2 microcontroler);

...

1. if the TE0300 module is used, the S2 switch must be turned on (RUN);
2. if the TE0320 module is used, the S1D switch must be turned on (RUN);

...

TE USB FX2 module is inserted in the USB port of the computer (aka plugged in, aka attached);

...

1. Generation 2: VID = 0x0547, PID = 0x1002;
2. Generation 3 : VID = 0x0BD0 , PID = 0x0300; 

...

• Cypress firmware update tools and OpenFutNet can read and write the EEPROM using:

  1. 1. CyControl (Cypress USB Control Center) or
        

     2. CyConsole (Cypress USB Console) or
     3. OpenFutNet or
        

     4. Open_FUT (gen 3)
        

See also Cypress USB Control Center update boot and Cypress USB Console update boot videos for further information about the procedures to follow.

Check that EEPROM connection is enabled (EEPROM switch is set in a way to enable EPPROM connection to USB FX2 microcontroler);

...

Cypress firmware update tools (Cypress USB Console recovery boot,Cypress USB Control Center recovery boot) and OpenFutNet (OpenFutNet recovery boot) can read and write the EEPROM.