Page History
...
- JTAG routing
- Boot Mode settings
- PUDC
- LED
Firmware Revision and supported PCB Revision
...
Name / opt. VHD Name | Direction | Pin | Bank Power | Description |
---|---|---|---|---|
C_TCK | in | 30 | 3.3VIN | JTAG B2B |
C_TDI | in | 32 | 3.3VIN | JTAG B2B |
C_TDO | out | 1 | 3.3VIN | JTAG B2B |
C_TMS | in | 29 | 3.3VIN | JTAG B2B |
EN1 | in | 27 | 3.3VIN | Power Enable from B2B Connector (Positive Enable) / Used only for PGOOD feedback |
User_LED | out | 4 | 3.3VIN | user defined or status, see LED description |
N.C. | 5 | 3.3VIN | / currently_not_used | |
JTAGEN | in | 26 | 3.3VIN | Enable JTAG access to CPLD for Firmware update (zero: JTAG routed to module, one: CPLD access) |
MODE | in | 25 | 3.3VIN | Boot Mode for Zynq/ZynqMP Devices (Flash or SD) |
MODE0 | out | 12 | 1.8V | ZynqMP Boot Mode Pin 0 |
MODE1 | out | 13 | 1.8V | ZynqMP Boot Mode Pin 1 |
MODE2 | out | 14 | 1.8V | ZynqMP Boot Mode Pin 2 |
MODE3 | out | 16 | 1.8V | ZynqMP Boot Mode Pin 3 |
NOSEQ | inout | 23 | 3.3VIN | usage CPLD Variant depends |
PGOOD | out | 28 | 3.3VIN | Module Power Good (only Feedback from EN1). |
PUDC_B | out | 17 | 1.8V | PUD_C → external pullup / currently_not_used |
TCK | out | 9 | 1.8V | JTAG ZynqMP |
TDI | out | 8 | 1.8V | JTAG ZynqMP |
TDO | in | 10 | 1.8V | JTAG ZynqMP |
TMS | out | 11 | 1.8V | JTAG ZynqMP |
X0 | in | 20 | VCCO_65 | FPGA IO (FPGA Pin H1B1) / Enable User LED (negative) |
X1 | in | 21 | VCCO_65 | FPGA IO (FPGA Pin J1C1)/ Connect to User LED |
Functional Description
...
Note |
---|
NOSEQ*: Please check the carrier board documentation, before using the SD/QSPI/JTAG firmware variant on TE0820TE0821. In the most cases special carrier CPLD firmware is needed. |
PUDC
const. 1 → The I/Os will be 3-stated after power-on when PUDC is High.
Power
PGOOD is EN1. There is no additional power management controlled by CPLD.
...
- REV00 to REV01
- copy of TE0820 CPLD Firmware
- changed PHY_LED1 in to PUDC_B out
- X0/X1 connected to other FPGA IOs
Document Change History
To get content of older revision got to "Change History" of this page and select older document revision number.
...
Overview
Content Tools