Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migration of unmigrated content due to installation of a new plugin

...

You can also use OpenFutNet: if used for Firwmare Recovery Boot or Firmware Upgade both EEPROM and RAM are programmed.

Warningnote
If you don't also write the IIC EEPROM ("Options"  > "EZ-USB Interface" > "Lg EEPROM" for CyConsole and "Program>FX2 64KB EEPROM" for CyControl), the new firmware is lost if the TE USB FX2 module goes under reset or power off/on cycle.

...

You can also use OpenFutNet: if used for Firwmare Recovery Boot or Firmware Upgade both EEPROM and RAM are programmed.

Warningnote

The firmware actually changes (it runs on USB FX2 microcontroller's RAM) only when

  • you reset the TE USB FX2 module;
  • you power off and power on the TE USB FX2 module;
  • you write the USB FX2 microcontroller's RAM (but the new firmware is lost if the TE USB FX2 module goes under reset or power off/on cycle).

FPGA Configuration (bitstream, RAM-like image)

Warningnote
If you don't also write the SPI Flash memory, the new bitstream image is lost if the TE USB FX2 module goes under reset or power off/on cycle.

...

...

Scroll pdf title
titleSPI Flash and FPGA connection; SPI Flash and USB FX2 microcontroller
TE USB FX2 module typeSPI Bus connection
TE0630
TE0320
TE0300

...

SPI Flash can be programmed in several ways:

...

  • USB connector
  • B2B connector
    • JTAG
    • Slave Parallel (SelectMAP)
    • Slave Serial
  • 6-pin JTAG header connector
  • 6-pin SPI header connector (TE0300 only)

...

Scroll pdf title
titleConfiguration modes overview.
TE USB FX2 module typeConfiguration mode connection
TE0630
TE0320
TE0300

...