Page History

To configure a TE0320 module via USB bus, there are different procedures to follow according to module status and purpose of use. For instance, a full quality control test already performed at Trenz Electronic laboratory premises requires all the following steps to be performed:

1. Cypress USB generic USB device driver installation
2. USB FX2 microcontroller large EEPROM programming
3. specific USB device driver installation
4. a an *.iic file generation

5. a firmware upgrade tool (Cypress tools: CyConsole or CyControlCenter TE tools: OpenFut, OpenFutNet or FX2EEPROMProgrammer) utilization.

   EEPROMrecovery

   step	first development cycle	following development cycles		EEPROM recovery (boot recovery)	quality control (lab test)
   (a1)			●	●
   (b2)			●	●
   (c3)	●			●
   (d4)	●	●		●
   (e5)	●	●		●

   Table 24: configuration steps via USB bus according to module status and purpose of use.