Configuration via USB bus

To configure a TE0320 module via USB bus, there are different procedures to follow according to module status and purpose of use. For instance, a full quality control test already performed at Trenz Electronic laboratory premises requires all the following steps to be performed:

1. generic USB device driver installation
2. USB FX2 microcontroller large EEPROM programming
3. specific USB device driver installation
4. a *.iic file generation
5. a firmware upgrade tool (Cypress tools: CyConsole or CyControlCenter TE tools: OpenFut, OpenFutNet or FX2EEPROMProgrammer) utilization.

   step	first development cycle	following development cycles	EEPROMrecovery	quality control (lab test)
   (a)			●	●
   (b)			●	●
   (c)	●			●
   (d)	●	●		●
   (e)	●	●		●

   Table 24: configuration steps via USB bus according to module status and purpose of use.