Page History

An update boot  (aka TE USB FX2 firmware update) is a multi-step boot operation:

...

1. if the TE0300 module is used, the S2 switch must be turned on (RUN);
2. if the TE0320 module is used, the S1D switch must be turned on (RUN);

...

TE USB FX2 module is inserted in the USB port of the computer (aka plugged in, aka attached);

...

1. Generation 2: VID = 0x0547, PID = 0x1002;
2. Generation 3 : VID = 0x0BD0 , PID = 0x0300; 

...

• follow the same procedure of TE USB FX2 driver installation (Generation 3)

• Check that EEPROM connection is enabled (EEPROM switch is set in a way to enable EPPROM connection to USB FX2 microcontroler);
  

  Warning
  EEPROM connection shall always be enabled during EEPROM programming.

• Cypress firmware update tools (Cypress USB Console recovery boot,Cypress USB Control Center recovery boot) and OpenFutNet (OpenFutNet recovery boot) can read and write the EEPROM.

  For example using CyControl (Cypress USB Control Center).