Page History
| Note | ||
|---|---|---|
| ||
The (generation 3)TE USB FX2 driver should be already installed and a Generation 3 firmware should be already programmed in USB FX2 microcontroller's EEPROM and RAM. |
An FPGA Configuration (aka TE USB FX2 SPI and FPGA programming) is a multi-step operation.
...
- A) TE USB FX2 module is seen under Device Driver as a Trenz Electronic Device.
- B) TE USB FX2 module is seen under Device Driver as a DEWESoft Device. In this case, you should start a Recovery boot procedure.
Open a USB Firmware Upgrade Tool (double click "ofut.py"). Case A is considered true from now on: TE USB FX2 module is seen under Device Driver as a Trenz Electronic Device.
...
Press the "..." button (it means “Select “Select *.bit or *mcs file, or enter file path”path”) at left of "Program FPGA" button corresponding to the firmware file pathname selection
Select a suitable *.bit or *.mcs FPGA bitstream file.
| Scroll Title | ||
|---|---|---|
| ||
 |
Press the “Program FPGA” button if you want the *.bit or *.mcs file to be written into the SPI Flash.
...
Overview
Content Tools