Page History

...

Reference Design is available on:

• TE0835 "Test Board" Reference Design

Software Setup

Download RF Analyzer GUI from the following link and install it.

...

1. Connect JTAG and power on carrier with module
2. Open Vivado Project with "vivado_open_existing_project_guimode.cmd" or if not created, create with "vivado_create_project_guimode.cmd"
3. Type on Vivado TCL Console: TE::pr_program_flash -swapp u-boot
   Note: To program with SDK/Vivado GUI, use special FSBL (zynqmp_fsbl_flash) on setup
             optional "TE::pr_program_flash -swapp hello_te0835" possible
4. Copy image.ub on SD-Card
   • use files from (<project foler>/_binaries_<Articel Name>)/boot_linux from generated binary folder,see: Get prebuilt boot binaries
   • or use prebuilt file location, see <design_name>/prebuilt/readme_file_location.txt
5. Insert SD-Card

...

1. Copy image.ub and Boot.bin on SD-Card
   • use files from (<project foler>/_binaries_<Articel Name>)/boot_linux from generated binary folder,see: Get prebuilt boot binaries
   • or use prebuilt file location, see <design_name>/prebuilt/readme_file_location.txt
2. Set Boot Mode to SD-Boot.
   • Depends on Carrier, see carrier TRM.
3. Insert SD-Card in SD-Slot.

...

1. Prepare HW like described on section TE0835 Test Board#Hardware Setup 111444625
2. Connect UART USB (most cases same as JTAG)
3. Select SD Card as Boot Mode (or QSPI - depending on step 1)
   Note: See TRM of the Carrier, which is used.
4. Power On PCB
   Note: 1. Zynqmp RFSoC Boot ROM loads FSBL from SD into OCM, 2. FSBL loads U-boot from SD into DDR, 3. U-boot load Linux from SD into DDR

...