Page History
...
| SBC Name | Connected | Notes |
|---|---|---|
| VDDIO | 3.3V | I/O Voltage fix 3.3V |
| VCCA | J1.17 B2B | Not used on board, external PNP Transistor not used, max 100mA |
| VAUX | - | Not connected, not used |
| SELECT | 5K1 to VPRE | Select 3.3V for VCCA Supply |
| MUX_OUT | XADC | |
| CAN RXD | MIO9 | |
| CAN TXD | MIO8 | |
| LIN RXD | PL Y14 | LIN Soft IP should be implemented in PL Fabric |
| LIN TXD | PL AA14 | |
| MOSI | MIO10 | |
| MISO | MIO11 | |
| SCK | MIO12 | |
| NCS | MIO13 | |
| DEBUG | J1.18 B2B | 11K Pull-down on module, defaults to debug mode DISABLED |
| IO_0 | J1.7 B2B | |
| IO_1 | J1.9 B2B | |
| IO_2 | J1.11 B2B | |
| IO_3 | J1.13 B2B | |
| IO_4 | J1.8 B2B | |
| IO_5 | J1.10 B2B | |
| INTB | J1.12 B2B | If connection to MIO or PL is needed must be implemented on base board |
| FS0B | J1.16 B2B | |
| RSTB | J1.14 B2B | Also forces system Reset |
| CANH | J1.2 B2B | 120R terminator on board, EMI and ESD should be on base board |
| CANL | J1.4 B2B | |
| LIN | J1.20 B2B | Any termination, ESD and EMI circuits should be on base board |
...
Overview
Content Tools