Page History
...
| Bank | Voltage | max. Value | note |
|---|---|---|---|
| 501 | 1,8 V | - | ETH0 / USB0 / SDIO0 |
| 500 | 3,3 V | - | SPI / I2C / UART |
| 502 | 1,5 V | - | DDR3-RAM |
| 13 | user | 3,3 V | connected to 3,3V by default by 0 Ohm Resistor R36 |
| 33 | user | 3,3 V | connected to 3,3V by default by 0 Ohm Resistor R55 |
| 34 | 2,5 V | - | ETH / DISP |
| 35 | 3,3 V | - | GPIO |
Initial Delivery state
| Storage device name | Content | Notes |
|---|---|---|
24AA025E48 EEPROMs | User content not programmed | Valid MAC Address from manufacturer |
| e-MMC memory | Empty, not programmed | Except serial number programmed by flash vendor |
SPI Flash OTP Area | Empty, not programmed | Except serial number programmed by flash vendor |
SPI Flash Quad Enable bit | Programmed | |
SPI Flash main array | demo design | |
EFUSE USER | Not programmed | |
EFUSE Security | Not programmed | |
Hardware Revision History
| Revision | Changes |
|---|---|
01 | Prototypes |
| 02 | Prototypes |
| 03 | First production release |
Technical Specification
Absolute Maximum Ratings
| Parameter | Min | Max | Units | Notes |
|---|---|---|---|---|
Vin supply voltage | -0.3 | 6.0 | V | |
Vin33 supply voltage | -0.4 | 3.6 | V | |
| VBat supply voltage | -1 | 6.0 | V | |
| PL IO Bank supply voltage for HR I/O banks (VCCO) | -0.5 | 3.6 | V | |
| I/O input voltage for HP I/O banks | -0.55 | VCCO_X+0.55 | V | TE0729 does not have HP banks |
Voltage on Module JTAG pins | -0.4 | VCCO_0+0.55 | V | VCCO_0 is 3.3V nominal |
Storage Temperature | -40 | +85 | C | |
| Storage Temperature without the ISL12020MIRZ | -55 | +100 | C |
Assembly variants for higher storage temperature range on request
Please check Xilinx Datasheet for complete list of Absolute maximum and recommended operating ratings for the Zynq device (DS181 Artix or DS182 Kintex).
Overview
Content Tools