Page History
...
For detailed information about the pin out, please refer to the Master Pinout Table.
Peripherals
LED's
There are 3 LED's on TE0729:
| LED | Color | Connected to | Notes |
|---|---|---|---|
| D1 | red | System Controller | Global Status LED |
| D2 | green | DONE | Inverted DONE, ON when FPGA not configured |
| D8 | red | MIO7 | OFF when PS7 not booted and not controlling MIO7 by software, else user controlled |
| Note |
|---|
LED D2 is connected to the FPGA Done pin and will go off as soon as PL is configured. This LED will not operate if the System Controller can not power on the 3.3V output rail that also powers the 3.3V circuitry on the module. |
Ethernet
D1 - Onboard RED LED
| 1 | Power problem |
| 2 | MGT Power problem |
| 3 | Reset from mainboard |
| 4 | FPGA not programmed |
This function depend on the CPLD revision.
D2 - Onboard GREEN LED
Green LED connected to MIO8
Ethernet
The TE0782 is equipped with two Marvell Alaska 88E1512 Gigabit Ethernet PHYs The TE0729 is equipped with a Marvell Alaska 88E1512 Gigabit Ethernet PHY (U3 ) and has in this TRM the identifier Ethernet0. The Ethernet0 PHY RGMII Interface is connected to the Zynq ETH0 PS GEM0. The I/O Voltage is fixed at 1.8V for HSTL signaling.
...
Overview
Content Tools