Page History

...

• Overvoltage-, undervoltage- and reversed- supply-voltage-protection
• Barrel jack for 12V power supply
• Carrier Board System-Controller-CPLD Lattice MachXO2 1200HC, programable by Mini-USB JTAG-Interface J7
• Zynq-module programable by ARM-JTAG-Interface-Connector (J15) or by System-Controller-CPLD via Mini-USB JTAG-Interface J7 or JTAG-Interface on FMC-Connector J10
• Mini CameraLink
• RJ45 Gigabit Ethernet Jack with 2 integrated LEDs.
• FPGA Mezzanine Card (FMC) Connector J10 for acces to Zynq-Module's LVDS-pairs, operable with adjustable IO-voltage FMC_VADJ
  
• USB JTAG- and UART-Interface (FTDI FT2232HQ) with Mini-USB-Connector J7
• ADV7511 HDMI Transmitter with HDMI-Connector J4
  
• 8 x user LEDs routed to System-Controller-CPLD, 8 x red
• 2 x user-push button routed to System-Controller-CPLD; by default configured as system "RESET" and "RESTART" button (depends on CPLD-Firmware)
  
• 2 x 4-bit DIP-Switch for base-board-configuration (3 switches routed to System-Controller-CPLD, 3 switches to set voltage FMC_VADJ, 1 switch routed to Zynq-module (MIO0), 1 switch enables Mini-USB JTAG-Interface J7)
  
• PMOD-Connectors to access Zynq-Module's LVDS-pairs and MIO-Pins
  
• Micro SD card socket, can be used to boot system
• Micro-USB-Interface (J12) connected to Zynq-module (Device, Host or OTG modes)
• Trenz 4x5 module Socket (3 x Samtec LSHM series connectors)

...

 All dimensions are given in mm.

Image RemovedImage Added

Figure 3: Physical Dimensions of the TE0701-05 06 carrier board

Operating Temperature Ranges

...