Page History
...
Additionally, on the TE0701 Carrier Board there is a 4-bit DIP-switch (S3; see (9) in Figure 1) available. The default S3 switch mapping is as follows:
| Switch | Functionality |
|---|---|
| S3-1 | CM1: Mode pin 1 (routed to Carrier Controller) |
| S3-2 | CM0: Mode pin 0 (routed to Carrier Controller) |
| S3-3 | JTAGEN: Set to ON for normal JTAG operation. Must be moved to OFF position for TE0701 System-Controller-CPLD update only |
| S3-4 | MIO0: Readable signal by System-Controller-CPLD and mounted TE07xx Module |
User-Push-Buttons
On the TE0701 Carrier Board there are two push buttons (S1 and S2) and are routed to the System-Controller-CPLD and available to the user. The default mapping of the push buttons is as follows:
...
Overview
Content Tools