Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

TE0722 need external 3.3V power supply. It is possible but not recommended to supply TE0722 with TE0790 programmer, but only for small designs (max ~100mA ~300mA over XMOD possible).

If TE0722 is powered via XMOD (max. ~ 100mA300mA), use XMOD DIP-Switch:

POSValue
1ON
2OFF
3ON
4ON

...

JTAG and UART is possible over J3 J2 connector.

Use XMOD (TE0790) Programmer with special firmware

XMOD Programmer support JTAG and UART over same USB cable.

Warning
  • XMOD DIP Switch settings: See power supply section
  • XMOD Firmware: Special XMOD CPLD Firmware is needed, see: TE0790 CPLD Firmware 

...

  • Firmware (SC-PGM-TE0790-0203_XMOD_DIP40-01_20170426) is available on : TE0790 Download Area/<Revision>/Firmware

Use other JTAG Programmer

...