Versions Compared

Old Version 16

changes.mady.by.user John Hartfiel

Saved on

compared with

New Version 17

changes.mady.by.user John Hartfiel

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

S3-3 (SC_SW1)S3-4 (SC_SW2)Description
OFFOFFSD1 Boot Mode (SD-Card on J11)
OFFONPJTAG0
ONOFFQSPI32
ONONJTAG

 

Display Port

OutputInput
DP_AUX_TXB66_T1
DP_AUX_DEnot B66_T2
B66_T3DP_AUX_RX
B67_T1DP_TX_HPD

SD

SD_EN is controlled by power management.

...

LEDDescription
LED4 (D16 red)

User FPGA IO IO B67_T3

LED3 (D15 green)User FPGA IO B67_T2
LED2 (D14 green)

PS Status. Status depends on blink sequence and priority.

  1. ********    : Reset button is pressed
  2. *****ooo   : Init_B failed
  3. ****oooo   : PS_Error_Status and PS_Error failed
  4. ***ooooo   : PS_Error_Status failed
  5. **oooooo  : PS_Error failed
  6. *ooooooo  : Done is low-> SoC PL not programmed
  7. LED OFF or ON : All ready → user defined from FPGA IO
LED4 (D13 green)Power LED. Status depends on blink sequence and priority.
  1. LED ON  : Power button is pressed
  2. ********    : Main power up failed
  3. *****ooo   : Main power error after successfully startup
  4. *****ooo   : MGT or Periphery power up failed
  5. ***ooooo  : MGT or Periphery power error after successfully startup
  6. **oooooo  : FMC power up failed
  7. *ooooooo : FMC power error after successfully startup
  8. LED OFF : Power good
FPGA XMOD (J24-XMOD2)

Boot Mode. Status depends on blink sequence and priority.

  1. LED ON  : JTAG
  2. ********    : Error unknown state
  3. *****ooo   : not used
  4. *****ooo   : not used
  5. ***ooooo  : not used
  6. **oooooo  : QSPI
  7. *ooooooo : PJTAG_0
  8. LED OFF : SD1
CPLD XMOD (J35-XMOD1)User FPGA IO

...