Page History
...
- Power Management
- Reset Management
- Boot Mode
- FAN Control
- LED Control
- FMC JTAG
- PJTAG
Firmware Revision and supported PCB Revision
...
Set DIP-Switch S3-2 to ON to get CPLD into JTAG Chain. This is only needed for CPLD update. Otherwise JTAG is routed thought FMCs or to PJTAG dependign on boot mode. JTAG is connected into cascade from FMC A to F, if module is detected, otherwise corresponding connector is left out.
| Boot Mode | Description |
|---|---|
| PJTAG0 | PJTAG MIOs are connected to JTAG chain |
| all other | FMC IOs are connected to JTAG chain |
Note: FPGA/SoC JTAG access is available directly over second XMOD.
...
Overview
Content Tools