Page History
...
Storage device name | Content | Notes |
|---|---|---|
QSPI Flash | Empty |
Boot Process
By default the ... supports QSPI and SD Card boot modes which is controlled by the MODE input signal from the B2B connector JM..
High or open | SD Card |
Low or ground | QSPI Interface |
Table 2: Selecting power-on boot device.
Signals, Interfaces and Pins
...
JTAG Signal | J2 Connector Pin |
|---|---|
| TCK | 4 |
| TDI | 9 |
| TDO | 10 |
| TMS | 8 |
On-board LEDs
| LED | Color | Connected To | Description and Notes |
|---|---|---|---|
| D1 | Red | LED2, U4 | |
| D2 | Green | MIO7, U1 | User controlled, default OFF (when PS7 has not been booted). |
| D3 | Red | LED1, U4 | |
| D4 | RGB | RGB_R, U1 RGB_G, U1 RGB_B, U1 | |
| D5 | Red | LED3, U4 | |
D6 | Green | DONE, U1 | Reflects inverted DONE signal. ON when FPGA is not configured, OFF as soon as PL is configured. |
...
Overview
Content Tools